Friction Proof No. 50 is our solution to treating surfaces where reduced friction is desired. Friction Proof can be applied to any piece of equipment, reducing the buildup of waxes, paper dust, clays, inks, offset, spray powders and other contaminates. It works wonderfully on cutting beds, cutting cylinders, counter plates and cutting dies. Using it on press feeders will enable sheets to glide effortlessly down the feed board, reducing feeding problems and increasing efficiency.
Directions For Use
1. Spray or wipe Friction Proof on any areas you wish to reduce friction.
2. Let the applied solution set for a few minutes prior to starting up.
3. Wipe off any excess product with a lint-free cloth or absorbent paper towel.
4. Friction Proof will leave a very slippery surface and protect against any sticking, dirt build-up or rust on metal or other surfaces.